IMS Magnetic & Industrial Products
IMS Home Page
Search
IMS Lifting Magnet Testing Service

LIFTING MAGNET TEST SERVICE

Our specially manufactured testing Frame is designed to allow a variety of testing arrangements for a Lifting and Holding magnets in many standard and specialty applications.

We test most brands of magnetic lifters.

What we do:

International Magnetic Solutions

  1. Tests most makes of magnetic lifters.
  2. Tests the Breakaway force of Lifting and clamping magnets on a flat, mild steel test piece.
  3. Visually inspect lifting magnets for defects.
  4. Provides a computer generated Test Certificate with Graphical Representation of the results.

We can also

  1. Test magnetic lifting equipment in special arrangements for specialist applications
  2. Take magnetic readings of the field strength of the magnetic device

Our technically qualified maintenance staff also Maintain and Repair magnetic equipment.

Our Reports:
Computer generated Test Certificate with Graphical Representation of the results gives a clear representation of the Magnetic Lifters performance characteristics.

Computer generated Test Certificate with Graphical Representation of the results gives a clear representation of the Magnetic Lifter’s performance characteristics.

Each certification confirms the actual Magnetic power is sufficient to provide the rated SWL of the magnet (including safety factors) and that the construction of the lifter and its safety measures are Safe for use. You may be required to produce a certificate in the event of an incident.

Our Test Frame:

Our specially manufactured testing Frame is designed to allow a variety of testing arrangements for a Lifting and Holding magnets in many standard and specialty applications.

This allows lifting magnets to be tested according to Australian Standard AS 4991-2004 which requires a tear-off force of at least 3 times rated capacity for permanent lifting magnets and at least 2 times rated capacity for battery-powered lifting magnets.

Depending on use it is recommended that lifting magnets are tested every 6 to 12 months.

Our Test equipment is certified:
The Load Cells and Strain Bridge Meter are certified accurate by a NATA approved testing body.

The Load Cells and Strain Bridge Meter are certified accurate by a NATA approved testing body.

The data from the Load Cell is transferred to a computer which produces Detailed Graphical Reports of the testing results which we provide for your records.

Always Check the Lifting Magnets before USE:

A pre-use check should always be conducted before a magnet is used. Check the operation of the handle, handle button, sliding key and security pin to ensure they are in good operating condition. Also check for excessive wear, corrosion or deformation of the lifting shackle. If there is any damage to the security function and it is no longer effective or the magnet has signs of deformation or excessive wear or corrosion the magnet shall be withdrawn from service immediately.

Always Check the Load condition before USE:

Place the magnetic lifter on the work piece surface in a position that will ensure an even lift.

The lifting capacity of the magnet is influenced by the thickness and surface finish of work piece. Before operation, it is necessary to inspect the work piece thickness to ascertain the likely lifting capacity of the magnet. Refer to the steel thickness lifting capacity curve shown on the side of the magnetic lifter and in the Operating manual.

One should also inspect the work piece surface finish. The magnetic lifter is designed for a smooth surface with full contact.

When lifting and handling cylindrical work pieces, the magnetic lifter should be placed on the cylindrical surface at a position where a balanced lift will be achieved. With a cylindrical surface the V-slot of the magnetic lifter contacts only along 2 lines hence the actual lifting capacity (SWL) of the magnet will be reduced to only 30-50% of the rated lifting capacity (SWL. The actual decrease of the lifting capacity is related to the diameter of the work piece being lifted.

A fully-certified testing service for magnetic lifters including test certificate. Available for most brands including SPD, Tecnomagnete, Eclipse, Bux, Braillon, Humphreys, Boxmag, Yale and more. Lifting Gear testing, inspection and certification for permanent and electro magnetic lifting systems, testing and tagging inspection of lifting equipment, tensile testing to W.L.L. / Working Load Limit.